Scottish oatcakes of yumminess!

As you know, Paul is diabetic, and I am always trying to find yummy sugar free food to bake or cook for him.

Paul tends to eat a bowl of oats with fresh fruit in the mornings but its getting boring. I work with a lot of UK products and last week, Scottish oatcakes kept popping up. So I googled and found a variety of recipes and yesterday I tried out a simple Scottish oatcake recipe.

These biscuits can be used in place of bread. Spread some butter, honey, jam or cheese on top or just have them plain right out the oven!

Scottish Oatcakes
Yields 16
A quick to make, yummy biscuit. Can be served with butter, cheese, jam or as is.
Write a review
Print
Prep Time
5 min
Cook Time
20 min
Total Time
25 min
Prep Time
5 min
Cook Time
20 min
Total Time
25 min
Ingredients
  1. 250g oats, whizzed in the blender until they become a flour consistency
  2. 25g butter, melted (I used margarine so they are dairy free, you could also use oil)
  3. 1/2 teaspoon bicarb of soda
  4. pinch of salt
  5. 150ml hot (not boiling) water
Instructions
  1. Preheat your oven to 180C.
  2. Set aside a bit of the oatmeal flour for later.
  3. Mix all the ingredients together until you have a rough dough ball.
  4. If its too sticky add some more oats, if its too dry add a dash of water.
  5. Dust your surface with the oatmeal flour you set aside earlier.
  6. Roll out the dough about 2-3mm thick.
  7. Take a clean glass and cut out rounds.
  8. You can re-roll the scraps until there is nothing left.
  9. Place rounds on a baking sheet and bake for 20 minutes.
Notes
  1. These were delicious fresh out the oven with a bit of butter.
  2. If you are not using them right away you can warm them up in the oven for a few minutes before serving although they are just as delicious cold.
  3. Store them in an airtight container.
Adapted from Penny's Recipes
Adapted from Penny's Recipes
A Bit of This A Bit of That https://gnatj.com/

One Reply to “Scottish oatcakes of yumminess!”

Leave a Reply

Your email address will not be published. Required fields are marked *